Your dream of accessing a blazing-fast internet connection will never get fulfilled if your router fails to connect to the internet. In this post, we’ve tried to figure out the reasons behind the Nighthawk router not connecting to internet issue. Not only this, but we’ve also highlighted the tips that you can follow to get the problem resolved. So, without any delay let’s start our Netgear router troubleshooting guide.
Nighthawk Router Not Connecting to Internet: Reasons
Given below are the reasons why your WiFi router is denying connection with the internet:
1. Damaged Ethernet Cable
The very first reason why you are facing the problem in the discussion is the use of a damaged Ethernet cable for the router-modem connection. Can you expect your devices to communicate directly if the cable connecting them is not in perfect condition? Of course not!
2. Excessive Distance from Modem
Being a wireless networking device, your Nighthawk WiFi router communicates with the modem via wireless signals too. If the distance through which your devices are separated is too much, then also you can face the Nighthawk router not connecting to internet issue.
So, these were the topmost reasons why a WiFi router refuses to connect to the internet. We are assuming that you’ve gained enough knowledge about them and hence it is time to shift focus to the troubleshooting section. But, before following any other technique, we advise you to try hands on the timeless IT hack of rebooting. FYI, rebooting a device helps in kicking off technical glitches. Chances are that the issue you are currently facing will also bid farewell. In case it doesn’t, you can always follow the hacks provided in the next section.
Nighthawk Router Not Connecting to Internet: Solutions
1. Change the Ethernet Cable
If the Ethernet cable connecting your Nighthawk WiFi router to the modem is found damaged, consider making use of a new cable. However, you must remember that using a new cable won’t bear any fruit if the connection created by you is shaky. Always make a finger-tight connection. Also, make sure that the Ethernet ports of your WiFi devices are working properly.
2. Mend the Router-Modem Distance
As mentioned earlier that the improper distance between your router and modem can also be the culprit, you are required to make amendments. Placing both devices closer will be a good idea. However, they must not be placed too close. Otherwise, you might end up struggling with other router-related issues. The value of the distance between your devices should be decided in such a manner that their WiFi signals neither clash nor struggle to communicate.
The Ultimate Hack
There are times when mending the connection between the router and modem doesn’t work in your favor. That can happen if you have not installed your WiFi router in a proper way. If that is also the case with you, then you’ve no option other than restoring the router to its default factory settings and setting it up from scratch. Just in case you don’t know the correct instructions to set up the router, take the help of the router’s user manual. From how to install router to reset it to the default settings. Not only this but, it also consists of a few tips that will help you avoid issues like Nighthawk router not connecting to internet.
All Things Considered
Since the router fetches the internet connection from the modem, it is clear that the Nighthawk router not connecting to internet issue has arisen due to their miscommunication. We hope that you’ve followed the workaround provided above and now your router has successfully connected to the internet.
However, you also need to ensure that your wireless router sits in an area free of WiFi interference and receives a continuous power supply from the wall socket.
